hello good everyone
I have a BMW 530d 218cv with a 6hp26 box but it is very bad, they offer me a 6hp26 but from a BMW 330d 231, would it be compatible?
If I assemble it, would I have to code something?
I have xhpflash paid, if I change it with reflashing xhp would everything be fine?
thanks in advance
Hi,i have a 2007 passat b6 2.0 TDI BKP,When i want to start it, It starts very bad but starts no fauld codes on vcds no injectors high values etc. After leaving it 10 min after i drove it it starts again bad,But if i stop the car after i started it,it starts good,Any clues? here s the bin if you want to have a look at it
Hi guys. i have on bench BCM fro jag xf DX23-14B471-AG MC9S12XET256. Problem i have is when attempting to read Dflash( as i want to clone it) it throwing error of sectors empty.
underneath message from Xhorse multi prog.
[ p, li { white-space: pre-wrap; } Buffer D-FLASH does not support validation! Initializing device... DB44 interface inserted Pin configuration completed Power setting in progress... port49:0 mv,port50:0 mv,port51:0 mv,port52:0 mv port53:0 mv,port54:0 mv,port55:0 mv,port56:0 mv vcc:0 mv,vdd:0 mv,vpp:0 mv Chip power configuration modified successfully! Chip power turned on Writing chip configuration information... Attempting to set crystal frequency to0x00000000 Set crystal frequency successfully! Chip configuration all successful! Querying chip basic information... Chip connection succeeded! Chip ID detection in progress... Chip ID detection succeeded! Chip ID is:1M53J|2M53J(C081) Chip unsecured Reading partition... Partition informationFLASH: 0 Sector(0K), EEPROM:8 Sector(2K) Start reading bufferD-FLASH Read length is 0, stop reading Ending process The chip power has been turned off!]
BCM Working when plugged in however i lost ac controll and reversing sensors due to corrosion and previous owner drilled holes in pcb board to jump cables hence replacement. I would greatly appreciate for advice of what am i doing wrong. thanks
hello .
Jumpy error P15a0, car does not have an original oil pressure sensor.
Is it possible to disable the strategy?
DTC off didn't solve it.
The vehicle loses power after a few km, it starts well and takes about 3 km to start limping.
Hi lads.. can some one assist with info what i need to r/w in pcm for immo off on P56041 on cherokee 4.0l 2000y. I try to read pin for key programing from skim eeprom, but is all in 00000. Some one messed up already before it comes to us. In skim and pcm
FLASH: 0 Sector(0K), EEPROM:8 Sector(2K)
